Deconstructed Cut-Out Lapel Crop Blazer

1. Collar to shoulder: Place the measuring tape at the middle of the collar and pull down to the tip of the shoulder
2. Shoulder to sleeve: Measure from the tip of the shoulder down to the bottom of the sleeve
3. Shoulder to shoulder: Place the measuring tape at the corner of one shoulder and pull across to the other shoulder. This is an important measurement as some people typically wear the same size but have different shoulder widths.
4. Upper arm width: Place the measuring tape in the middle of the upper arm and measure from one side of the sleeve to the other.This measurement is important when it comes to bicep size.
5. Forearm width: Place the measuring tape in the middle of the forearm and measure from one side of the sleeve across to the other.
6. Chest width: Measure from the bottom of one armhole across the chest to the bottom of the opposite armhole.
7. Waist width: Place the measuring tape where the natural waist would fall, usually a bit lower than halfway down the blazer, and measure from one side of the jacket across to the other.
8. Front length: Place the measuring tape in the middle of the collar and pull it down vertically to the bottom of the jacket.
9. Hip width: Measure from one of the bottom corners of the jacket across to the other.
10. Sleeve hole width: Measure the width of the sleeve by placing the measuring tape at one corner of the sleeve hold and pulling it across to the other side.
11. All done!

1. Neck to Shoulder: Measure from the middle of the neck to end of shoulder (where the sleeve starts).
2. Sleeve length (A): Measure from the center back of collar to the end of shoulder.
3. Sleeve length (B): Measure from the shoulder to the wrist.
4. Shoulder to Shoulder: Measure this length from one shoulder to another.
5. Chest: Measure around the fullest part, place the tape close under the arms and make sure the tape is flat across the back.
6. Front Length: Measure from the highest point of the shoulder to the desired hemline.
7. Hem: Measure from one side to another, but it is vital to take this measurement from above the elastic area (If sweatshirt have any).
8. Sleeve cuff: At the widest point of the wrist, measure its circumference. Leave enough room for watches or jewelry worn often. Take this measurement from above the elastic area same as Hem length measurement

Sizes can vary from 2-3 centimeters because they are measured by hand. 1inch=2.54cm The size matched on a label can differ from the one you have ordered